Hello Sign In
Welcome to FlorianiCommercial.com
0 items in your bag
 

Sign In

Subscribe

"Hard To Hoop" Items

Hard to Hoop Items Such As Shirt Collars, Cuffs, Napkin Edges, Socks, Tote Bags, Pocket Tops, Ties, Etc.

Floriani Wet N Stick®
is the recommended stabilizer for theses projects. To use Wet N Stick®:

  1. Place one piece of Wet N Stick®, shiny side up, into the hoop and make sure it is "tambourine skin" tight.
  2. Apply a small amount of water to each corner and one drop in the center using a foam paint brush, envelope sealer, or sponge. Do not spritz or mist the water. Spread the water over the surface of the stabilizer with your finger and you will feel it become tacky almost instantly.
  3. Immediately apply the item to be embroidered to the hooped stabilizer and smooth out any wrinkles. Allow a few seconds for the item to adhere to the stabilizer so that it doesn't shift during the embroidery process.
  4. Complete the embroidery as normal.
  5. After the design is done simply tear away the Wet N Stick®.

*Note: If you accidentally used too much water and find the item wants to be "as one" with the stabilizer simply lift the corner of the item, re-wet the stabilizer at the glue line and peel the item back as the "sticky" becomes activated again.

On average, Floriani Wet N Stick® should support a design with no more than 10,000 stitches and/or around 4" x 5" in size. If the design has a higher stitch count, simply "float" a square of Floriani Medium TearAway between the hoop and the bed of the machine to support the additional stitches. And don't forget your topping if working with uneven textures!


Back to parent page

"On a personal note, the Floriani stabilizers are the best on the planet, wonderful results, without the 'worry' of ANY puckering- Thank you!"

Edies Embroidery


Read More

 
About Floriani Commercial Floriani Commercial Policies Floriani Commercial FAQ Floriani Commercial Resources
Close
Loading...